Lock the dishwasher by pressing the control button for 3 seconds.
Locked dishwasher door.
Check to be sure that the strike plate is properly aligned.
3 dishwasher door strike plate the dishwasher strike plate is located on the dishwasher frame.
If out of alignemnt the dishwasher door latch cannot connect to it and the door will not close.
The second is to activate the safety switch.
This is the part that the dishwasher door lock latch hooks into when the door is closed.
Here is a link for the owner s manual on this dishwasher in case you need it.
Look for any cracks damage or large debris that could be preventing the door from sealing completely.
The latch can 39 t be reset if it went into the door lock position when the door was open.
The control lock deactivates the control panel touchpad keys so the washer cannot be started but still allows the door to be opened.
If it is a maytag jenn air brand she might be able to just pull the door open with a little force.
When the dishwasher door latch does not operate as it should your machine will not run this can be a major annoyance but should also be an easy thing to repair.
First check your dishwasher door and door gasket.
The first is to pull the door tight and keep it closed to prevent water leaks.
Troubleshooting lock mode when you press one of the control buttons while the dishwasher is in lock mode the button should flash only four times.
The available buttons differ from model to.
Use the control lock 4 hour delay or whatever button you used to disengage the lock.
Actually most dishwashers do not have the ability to lock the door.
The reason this happens is because the plastic on the latch starts to warp over time and then instead of flicking backwards when you open the door it will flip forward and over extend past the locking position since there is no latch striker to stop it.
The control panel is above or on the upper edge of the dishwasher door.
Even though none of the controls works in lock mode you can still open the dishwasher door.
The latch serves two purposes.
Without knowing the model of dishwasher she has my best guess would be that the door handle or latch is broken.
Holding the heated dry key would only lock or unlock the controls.
Has anyone run into this or have any thoughts on how to least destructively get this thing.
The handle to open the door has somehow broken and it does not seem possible to open the door.
Hold it down until the red light labeled control locked blinks on.
Try cleaning your door gasket with a.
The control should then work normally.
The control lock function on a whirlpool dishwasher is a child safety feature.